Assemble a desktop pc using your own hand

willing to assemble a desktop ?
so ,


First you need to collect some parts :

1. Motherboard

2. Processor

3. Processor fan

4. Ram (random access memory)

5. Sata / Pata cables (serial / parallel advanced technology attachment)

6. Hard disc drive

7. CD / DVD Drive

8. SMPS (switch mode power supply)

9. Heat sink paste

10. Cabinet (chasys)

11. Sata power cables (if unavailable in SMPS)

now get ready >>

first take motherboard in your hand

then insert processor in its slot according to this picture.

Remember : notch should not be misfitted unless slot clip will not close properly 

then close its clip.

then open the ram slot clip opposite to each other and then insert ram according to its notch.
fit it properly unless nothing will display in the monitor.

after that insert the processor fan over the processor slot according to this picture.

Note : around the processor slot you will find four holes.

now you will find arrow like structure bottom of the processor fan, insert it into the hole around the processor slot.

then insert the processor fan's power cable into the motherboard's 'cpufan' switch beside the processor slot.

 now insert motherboard into the cabinet and titetivate all screws properly.

like this

just before this step attach the flap (rear) of motherboard into the cabinet.

then the next step is to attach the SMPS in cabinet and install this 20+4 cable into the motherboard.

Note : only two fixed slots found to insert these cables into the motherboard

now insert all the sata and pata power/signal cables into the motherboard

and all the CD/DVD , Hard disc drive in cabinet

like this Î

after all install all  cables between drives,cabinets and motherboard using installation mannual of the motherboard.

Now your CPU is ready to use.

Note : you can take additional help with your motherboard user/instrallation mannual guide.

You liked this post ?

Subscribe to our feed.