One of the components of the Internet connection on your computer is a built-in set of instructions called TCP/IP. TCP/IP can sometimes become damaged or corrupted. If you cannot connect to the Internet and you have tried all other methods to resolve the problem, TCP/IP might be causing it.
Because TCP/IP is a core component of Windows, you cannot remove it. However, you can reset TCP/IP to its original state by using the NetShell utility (netsh).
This post describes technical support ways to reset TCP/IP. You must be logged on to the computer as an administrator.
Use a manual method to reset TCP/IP
The reset command is available in the IP context of the NetShell utility. Follow these steps to use the reset command to reset TCP/IP manually:
1. To open a command prompt, click Start and then click Run. Copy and paste (or type) the following command in the Open box and then press ENTER:
cmd
2. At the command prompt, copy and paste (or type) the following command and then press ENTER:
netsh int ip reset c:\resetlog.txt
Note If you do not want to specify a directory path for the log file, use the following command:
netsh int ip reset resetlog.txt
3. Reboot the computer.
For Advance troubleshooting use computer support service
