Install Gingerbread 2.3.3 in Motorola Droid X

If not wait for the OTA update in Droid Gingerbread X, you can download it and install it manually with the steps that we provide this. But keep in mind this is not the official version, so every decision is yours.

- Before you start the whole process make sure the phone meets all the requirements below:

1. The phone uses the official Froyo Firmware 2.3.340
2. The phone in a state rooted
3. The phone uses Droid2 Bootstrap program (DO NOT USE DroidX Bootstrap)

- After making sure the phone has met the three requirements above, start with these steps:

1. Download all 3 files in the root of this and place it in SDCARD

Install Files Part 1
md5 = 55903982607d3b1b22b3b9f3af1ff807
size = 99.1 MB (103,875,449 bytes)

- Download Part 1 - Mirror 1
- Download Part 1 - Mirror 2
- Download Part 1 - Mirror 3

Install Files Part 2
md5 = a021e4e0dffb39018bdabf7e679f4d35
size = 16.2 MB (17,028,214 bytes)

- Download Part 2 - Mirror 1
- Download Part 2 - Mirror 2
- Download Part 2 - Mirror 3

Install Files Part 3
md5 = 7cb97560c1f757ad2b9ccd131200911b
size = 220.7 KB (226,025 bytes)

- Download Part 3 - Mirror 1
- Download Part 3 - Mirror 2
- Download Part 3 - Mirror 3

2. Bootstrap Droid2 Restart in recovery mode.
3. Install the three zip files in order.

IMPORTANT:
- DO NOT LEAVE UNTIL ALL RECOVERY (THREE) installed FINISHED FILES

Most of the install with the 2.3.340 firmware update does not need to do a wipe, 15% of them do the wipe. So, the choice is yours;)

For those of you who already installed with firmware leaked Gingerbread 4.5.573, perform the following steps:
1. Perform backup using recovery Clockwork
2. Downgrade to firmware 2.3.340
3. Do it all over the upgrade process
4. After the upgrade is complete, go in recovery Bootstrap
5. Do Andanced Restore - Select Data